How do I get a program to run from postprocessing.bat?

[dvasco]

ok, adding %1 to mpg2srt got that to run. I set rem before rename recording until I can figure out how to get that to rename all of the files.

[dark_half]

From reading the wiki about renamerecording it sounds like it will change the comskip file name also. I have never used it but that was the impression I got. You just need to move it to the end after mpg2srt.

[dvasco]

From reading the wiki about renamerecording it sounds like it will change the comskip file name also. I have never used it but that was the impression I got. You just need to move it to the end after mpg2srt.

And have it rename the files from mpg2srt, which are simply .smi and .srt files compiled from the CC captured by the PVR-350.

[dark_half]

Ok i see your problem. I did not look to see what the purpose of mpg2srt was. I am not sure how to get those files renamed but I will think about it an if I come up with anything I will reply. I am sure someone here can help you figure it out. I do have a question what is output to the rename.log?