2008-02-02, 09:37 PM
Hi all!
I just switched TV providers from direct analog cable to IPTV via a set-top-box.
I found the new provider (ATT UVerse, for what it's worth) in the schedules direct listings for my area. In Config, I did the following:
1. Capture Sources
2. Select capture device
3. Edit
4. Empty EPG
5. Update EPG
After this, the channel list contained channels from both the old and new providers.
I used the "Remove" button on all channels on the list.
"update EPG" again and now only the new channels are displayed. Also all the channels have the appropriate channel number for that channel.
Hit "OK".
Now, on the "Channels" tab there are channels that are have the wrong channel number for my listings. And there are channels that would have been correct on the previous provider, but are wrong on the current provider.
Is there a way to force GBPVR to reload this list of channels so that it matches the list downloaded for the EPG?
Thanks in advance for your help!
Mike
I just switched TV providers from direct analog cable to IPTV via a set-top-box.
I found the new provider (ATT UVerse, for what it's worth) in the schedules direct listings for my area. In Config, I did the following:
1. Capture Sources
2. Select capture device
3. Edit
4. Empty EPG
5. Update EPG
After this, the channel list contained channels from both the old and new providers.
I used the "Remove" button on all channels on the list.
"update EPG" again and now only the new channels are displayed. Also all the channels have the appropriate channel number for that channel.
Hit "OK".
Now, on the "Channels" tab there are channels that are have the wrong channel number for my listings. And there are channels that would have been correct on the previous provider, but are wrong on the current provider.
Is there a way to force GBPVR to reload this list of channels so that it matches the list downloaded for the EPG?
Thanks in advance for your help!
Mike