NMR doesn't find mvpmc server

[JonnyCam]

Hey,

When I try and load mvpmc on the pch, it changes the video mode etc and looks like it will start, then screen stays blanks for a while, then NMT restarts.

I can see a PVRX2 session running on the PC, and I checked the extensions button, and port 7647 is open for EWA.

I ran the telnet session from my pc, using /etc/mvpmc2, as below.

Code:

pixel format 200808 200808
Other layer 640 576
av 2 pal
Using interface eth0
Querying host parameters
media thread started (pid 2014)
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
Querying host parameters
No server found
(*) SMP863x: ------------------------ em86_free_layer_surface la
-----------------------
(*) SMP863x: ------------------------ em86_free_layer_surface la
-----------------------
(*) SMP863x: ------------------------ em86_free_layer_surface la
-----------------------
(*) SMP863x: em86_main_video_scaler_deinterlace: mode=0
(*) Deinterlacing config: Discard/Bob; using_xlacing_motion_scal
[src/mem_mngr.c:696] MRUA memory map ID MMAP_DirectFB_BASE (0xfc
[src/mem_mngr.c:696] MRUA memory map ID MMAP_VIDEO_2_BASE (0x800
[src/mem_mngr.c:853] DCC-HD MRUA memory allocator uninitalized
(!) System is going down !!
(!) System is down!!

Any Ideas as to why this would happen? Full telnet attached.

Cheers

[mvallevand]

You need to have your firewall open for GBRecordingService.exe for TCPand UDP. Also you have to Autostart an MVP Server in config.exe. If you already have an MVP you may need to increase the count.

Martin