2008-03-27, 11:31 PM
Hey Everyone,
Aplogies if this has been covered elsewhere - ive done a few searches but havent found the exact issue i have...
My PC previously had a Hauppauge NOVA-S-PLUS card with the jackpoint for a hauppauge remote , I also had an analogue PVR150 card.
Since there was only 1 card in the system that supported the remote - this all worked fine and dandy.
Last night i added another card to the equation - a Hauppauge HVR-4000 for the DVB-T side of things (and addtional sat source).
Ive been able to pick up sat and DVB-T (and seem to have have analogue side of it working too) - so might be able to remove the PVR150.
My only issue is this - my formerly working remote doesnt work at all !!
Ive tried plugging into the nova-s (where it was previously) - ive also tried plugging into the HVR-4000 .... and neither seem to do anything.
I had the direct access to hauppauge turned off via the gbpvr config previously - as more of the buttons on my 45 button remote seemed to function when using it non-directly using the hauppauge IRremote software.
Any ideas / tips / tricks on how to get my remote working again - as my pc is pretty much useless without a remote.
:confused: :confused:
Aplogies if this has been covered elsewhere - ive done a few searches but havent found the exact issue i have...
My PC previously had a Hauppauge NOVA-S-PLUS card with the jackpoint for a hauppauge remote , I also had an analogue PVR150 card.
Since there was only 1 card in the system that supported the remote - this all worked fine and dandy.
Last night i added another card to the equation - a Hauppauge HVR-4000 for the DVB-T side of things (and addtional sat source).
Ive been able to pick up sat and DVB-T (and seem to have have analogue side of it working too) - so might be able to remove the PVR150.
My only issue is this - my formerly working remote doesnt work at all !!
Ive tried plugging into the nova-s (where it was previously) - ive also tried plugging into the HVR-4000 .... and neither seem to do anything.
I had the direct access to hauppauge turned off via the gbpvr config previously - as more of the buttons on my 45 button remote seemed to function when using it non-directly using the hauppauge IRremote software.
Any ideas / tips / tricks on how to get my remote working again - as my pc is pretty much useless without a remote.
:confused: :confused:
Regards,
Kyle Brophy
IT Manager
Christchurch
New Zealand
nPVR HTPC v3.1.1 (Multidec and also Hauppauge WinTV-CI and Irdeto CAM)
ASUS P5Q SE/R, Core 2 Quad 2.66GHz, 16GB RAM, Windows 7 (64 bit), 2TB (recordings) + 2TB (Movie)
KU: Fixed 90cm - D1,D3,C1
Kyle Brophy
IT Manager
Christchurch
New Zealand
nPVR HTPC v3.1.1 (Multidec and also Hauppauge WinTV-CI and Irdeto CAM)
ASUS P5Q SE/R, Core 2 Quad 2.66GHz, 16GB RAM, Windows 7 (64 bit), 2TB (recordings) + 2TB (Movie)
KU: Fixed 90cm - D1,D3,C1