2009-02-07, 10:47 PM
I'm trying to set up the second analog tuner for my 2250 now, and it's been giving me problems. When I first create it under Capture Sources in config, and try to click Ok, it give me an error message: "The Drivers for the device you have configured do not seem to be installed. Are you sure you want to save these current settings?"
This time, just to be sure my logs would show it, I said yes, updated my epg, and then went into pvrx2, set up two analog recordings (convertx = device 1, 2250 analog 1 = device 2 and the new troublesome 2250 tuner = device 3), and then tried to watch a 3rd analog channel to see if the new tuner might work anyway, predictably, it doesn't--there was just a blank screen when I tried to watch the show, and then it went back to the TV Guide when I clicked, though the other two recorded fine. This was the last thing I did before zipping the logs, so it should be right at the end.
Of course, the drivers are installed, and GBPVR works fine with the first analog tuner. Just not the second one.
My drivers are listed in my sig. Thanks in advance for any tips you might have.
This time, just to be sure my logs would show it, I said yes, updated my epg, and then went into pvrx2, set up two analog recordings (convertx = device 1, 2250 analog 1 = device 2 and the new troublesome 2250 tuner = device 3), and then tried to watch a 3rd analog channel to see if the new tuner might work anyway, predictably, it doesn't--there was just a blank screen when I tried to watch the show, and then it went back to the TV Guide when I clicked, though the other two recorded fine. This was the last thing I did before zipping the logs, so it should be right at the end.
Of course, the drivers are installed, and GBPVR works fine with the first analog tuner. Just not the second one.
My drivers are listed in my sig. Thanks in advance for any tips you might have.
