2nd MVP "Loading Application"

[gblinckmann]

I've got two MVP's that I've been running for a long time. Lately, one of them doesn't seem to want to connect to GBPVR. Running the native software, both work fine. The second MVP will only run GBPVR if I stop GBPVR, run the hauppauge software, then boot both MediaMVP's, then stop the Hauppauge software and start GBPVR.

Any ideas, anybody? This type of procedure hits the WAF hard!

[AOSandman]

Also add these two lines to your router for MVP

Media MVP Control
Port: 8300 to 8337
Both Direction TCP/UDP
IP for your PC that runs GBPVR
Enable

Media MVP Stream
Port: 5900 to 5906
Both Direction TCP/UDP
IP for your PC that runs GBPVR
Enable

:confused: Are you trying to serve MVPs that are on the internet? You DO NOT need to open any ports on your router.