Problems since Digital switchover

[Glynderi]

Hooray! Sorted.

I went to Plan B - uninstalled GBPVR, deleted the whole DENZ folder and reinstalled.
Unzipped the 0128DSD file into the appropriate folder and set up the 2 cards.

Kerr-ching! It all works - which means that I now have programs in the TV Guide.

Just got to test the recording process, but I'm sure that will work.

Thanks for all the advice & help. :o)

Robin

[ACTCMS]

Hooray! Sorted.

Great - it would be interesting to know if you are seeing all available channels.

[Glynderi]

Well, I was seeing all channels until last week (1st Dec), now I have largely nothing, apart from the odd channel. I'm back to where I was weeks ago.

I've re-installed, rescanned, done everything I can.

Advice greatly welcomed.

Logs attached.

Robin

[ACTCMS]

I've re-installed, rescanned, done everything I can.

After you re-installed did you install this patch? Also after you re-scanned, did you make sure that the Audio#2 channels were left unchecked?

[Graham]

Did you select Country = "UK after DSO" from the dropdown list in the scanning wotnot?

[bethanyrayne]

Well, I was seeing all channels until last week (1st Dec), now I have largely nothing, apart from the odd channel. I'm back to where I was weeks ago.

I've re-installed, rescanned, done everything I can.

Advice greatly welcomed.

Logs attached.

Robin

Remove capture sources completely.
Add capture sources and scan ALL Regions All Channels
When scan completed add ITV1 only don't update EPG when requested
ITV1 will have been added with Audio2 Highlight and click remove
Click map digital channels ( don't rescan) and enable all the channels you want.
Rinse and repeat for each capture source then update EPG for each source.
Unfortunately you'll have to rescan to add channels that don't transmit all day in this case Audio2 will get back into your list.
Just remove all Audio2 Channels and add them again and all will be well.

[Glynderi]

Did you select Country = "UK after DSO" from the dropdown list in the scanning wotnot?

There's no "UK after DSO" in the drop-down list, but I wonder if the config file I've just been advised to install fixes that issue.

I'll try the 3 pieces of advice in order.

Thanks, guys. :-)

[Graham]

There's no "UK after DSO" in the drop-down list,

My mistake. The .INI attached earlier contains ...

Code:

[TERTYPE]
1=Wales
2=Carmel after DSO
[DVB]
0=7
1=C52,722000,0,0,8
2=C53,730000,0,0,8
3=C54,738000,0,0,8
4=C57,762000,0,0,8
5=C58,770000,0,0,8
6=C60,786000,0,0,8
7=C61,794000,0,0,8

This should give you a country of Wales and a Region of Carmel after DSO.

[Glynderi]

Ah, right. Yes, I have/had that.

[Glynderi]

Remove capture sources completely.
Add capture sources and scan ALL Regions All Channels
When scan completed add ITV1 only don't update EPG when requested
ITV1 will have been added with Audio2 Highlight and click remove
Click map digital channels ( don't rescan) and enable all the channels you want.
Rinse and repeat for each capture source then update EPG for each source.
Unfortunately you'll have to rescan to add channels that don't transmit all day in this case Audio2 will get back into your list.
Just remove all Audio2 Channels and add them again and all will be well.

Great. That's worked perfectly!

Thank you very much.

Robin.