Cannot get mcpmcx2 working after re-install - help

[mvallevand]

It's the same place, but I yes I absolutely wanted the old logs. The MVP.log is the next connection.

Martin

[StevHodge]

OK here they are - hope there enough. I have done more than one nrecord restart

Steve

[mvallevand]

The .3 log in this case is the correct one, but it just shows a disconnect when NextPVR is sending data. If you disable the screen saver does anything show?

Martin

[mvallevand]

I have attached a new version with some more debug info and extract it to the mvpmc share and run

/etc/mvpmc/mvpmcx2debug

Also enable this in the MVP section of config.xml and send all the logs.

<ExtendedLogging>true</ExtendedLogging>

Martin

[StevHodge]

Here they are. mvpmcx2debug seemed to be looping. I left it for five minutes then killed it. Hope this is OK

Steve

[mvallevand]

Here they are. mvpmcx2debug seemed to be looping. I left it for five minutes then killed it. Hope this is OK

Steve

Unfortunately those logs indicate that you should be getting a display. Its not looping, the rfb handshake is good and mvpmcx2 is doing exactly what it should telling NextPVR it is there, and I see the send/receive of the time every minute. Did you try turning of the TV to reset it?

Martin

[StevHodge]

OK Martin I'll have a go at the TVs tomorrow. It seems odd. it behaves the same way with two different TVs and HDMI cables. I'll try another one and also component and composite feeds.

Steve

[mvallevand]

OK Martin I'll have a go at the TVs tomorrow. It seems odd. it behaves the same way with two different TVs and HDMI cables. I'll try another one and also component and composite feeds.

Steve

Start with component since it has the same config.xml setting. The HDMI interchange looks good too so this is definitely difficult.

Martin

[StevHodge]

No success really
Tried component and composite, same result. For one brief moment on composite I got the UI, but it went away almost immediately.
Attached the relevant logs. They are run with the 'startmeup' line commented out, otherwise the puTTy log seems very short. (The composite was run on a TV for which the config file wasn't correct)
I have got a work-around, which may perhaps be relevant. I can set up share on the PCH pointing at the NPVR recordings directory on the server, and this works fine. But I really miss the NPVR UI. Obviously with the work-around I just get a rather unfriendly file listing

[mvallevand]

No success really
Tried component and composite, same result. For one brief moment on composite I got the UI, but it went away almost immediately.
Attached the relevant logs. They are run with the 'startmeup' line commented out, otherwise the puTTy log seems very short. (The composite was run on a TV for which the config file wasn't correct)
I have got a work-around, which may perhaps be relevant. I can set up share on the PCH pointing at the NPVR recordings directory on the server, and this works fine. But I really miss the NPVR UI. Obviously with the work-around I just get a rather unfriendly file listing

For composite you forgot to change the res to 800x600 I did notice you still have the screen saver on I asked you to turn it off for now.

Yes as I wrote you do need to comment out startmeup

If you can play videos with the NMT menu on, I can't see why this won't work.

There is one mvp.log where it ran for 3 hours any idea what that was?

Martin