Edit Recording Source Problem

[baff57]

When trying to Map digital Channels to EPG Channels i get the following Message:-
GB-PVR was unable to start the BDA device you have configured, check the device is configured properly and not already in use.
I have installed the MCE plugin DTV-T emulator for the Twinhan card but comes up with the same when i turn it off. Anyway the first time i used this it mapped them fine with it running.
I have checked the button (only show cards detected) 3 listed and none work, they all do the same.


Help!!!

[sub]

can you reproduce the problem, then zip and attach your config.exe.log and config.exe-native.log files?

[baff57]

I have deleted the configuration and and started again and it is scanning, is it normal to report signal 0 quality 0 and still list channels being found???

Best regards

david

[baff57]

I have now scanned and it sees the channels names but when i click on them no picture!!! i trust this is due to the 0% signal and 0% quality.
I have set it up as Astra 2A and my normal signal strength is 100% quality 95% strength.
I am not using Diseq and the dish is fixed.

Hardware:

Gigabyte GA-K8NSC-939, 2gb DDR Ram
AMD Athalon 64 3500
ATI Radeon 9800 Pro
2 x Sata 250 gb drives
Twinhan DTV Sat-CI 1030A serial number 05014A00675
Wireless PCI card
No Bluetooth Devices Installed
Not Overclocking

Drivers:
Video driver Version ATI 8.231.0.0 21/2/06
Twinhan Driver Version 1.2.3.8

Software:
Windows XP Media center edition
Service Pack 2 Installed
Direcx X 9.0c installed
Power DVD 6.0 OEM 6 ch installed
WinDVD not installed
DTV Application not installed DVB-S MCE Plug is installed

Signal Environment:
Based in UK, Cornwall on the Lizard.
Exterior 80 cm dish with .2 db LNB
Its a twin LNB and feeds computer and s*y box.
I am not sure on cable manufacturer but was best i could buy
No splitters or amplifier.