Recording file cant be found

[sub]

The difference in the MP config is that it only allows to use the Microsoft DVR-MS muxer (never used that in GBPVR because I need mpegs).

You can always set GB-PVR to record using DVR-MS, then tell it to automatically convert recordings from DVR-MS to MPEG2. This doesnt involve any transcoding and only takes a couple minutes after the recording completes. It would at least worth doing this to check if you still have the problem.

Could the muxer be the cause of my problems? What muxer would you recommend?

Yes. As I've said a few times, it sounds like either the mux or device (or its drivers) to me.

[chris-at]

You can always set GB-PVR to record using DVR-MS, then tell it to automatically convert recordings from DVR-MS to MPEG2. This doesnt involve any transcoding and only takes a couple minutes after the recording completes. It would at least worth doing this to check if you still have the problem.

Yes, I've already tested it with the DVR-MS. Unfortunately this didn't change anything.

Yes. As I've said a few times, it sounds like either the mux or device (or its drivers) to me.

Sorry sub but I'm a bit frustrated. I think I've tried every configuration setting and mux combination I can think of at least 5 times. And I still get the same undescriptive error.

I did at least 30 recordings with Media Portal without problems - so I'd bet that it's a bug in GBPVR.

Too bad GBPVR isn't open source. I'd love to debug this to try to fix it.

Thanks for your efforts though!

[sub]

Ok, fair enough. At least you tried.