New installation two issues

[jphhughes]

I just install GBPVR 9808 and have two issues. I have searched the forum and found other with similar issues but did not find any resolutions. So here are the problems.

1 I have a Hauppauge 250 FM card and a Hauppauge 150 (no FM) installed. When configuring the capture devices if I select show only detected cards it shows 250 with FM, 250 , and 350 but no 150. I also don’t have a 350 installed. I can leave the detect box unchecked and not worry about it, but this seems questionable. So should I not worry about it? It seem both cards are working ok with recording and Live TV.

2 Whenever I am watching Live TV and have a show schedule for recording, when the show start to records GBPVR switched to that tuner. At that point if I key in the previous channel number and hit enter noting happens. If I bring up the mini guide and go to the previous channel and hit enter it will make the channel change. Although this is not a critical problem it is very annoying. So if any can suggest a remedy It would be greatly appreciated

[sub]

1 I have a Hauppauge 250 FM card and a Hauppauge 150 (no FM) installed. When configuring the capture devices if I select show only detected cards it shows 250 with FM, 250 , and 350 but no 150. I also don’t have a 350 installed. I can leave the detect box unchecked and not worry about it, but this seems questionable. So should I not worry about it? It seem both cards are working ok with recording and Live TV.

Just ignore this, and set up a capture source for your PVR250 and a capture source for your PVR150. Set one as device #1, one as device #2. If things dont seem to work, then the device numbers will need to be swapped.

2 Whenever I am watching Live TV and have a show schedule for recording, when the show start to records GBPVR switched to that tuner. At that point if I key in the previous channel number and hit enter noting happens. If I bring up the mini guide and go to the previous channel and hit enter it will make the channel change. Although this is not a critical problem it is very annoying. So if any can suggest a remedy It would be greatly appreciated

This is probably because you've got the device numbers both entered as device #1?

[jphhughes]

I did as you suggested and everything is working fine now. Revercing the capture card device numbers was necessary ito get it working. Thanks for the help.