Setting up Twinhan 102g with new release

[ashwincr]

if you decide to scan them, do post your results, I am going to try with this new psiparser

[sub]

The log looks fine.

Honestly, I cant see that one line change between those two versions of GBPVRPsiParser.ax causing this stuttering. The change would only affect HDTV channels (with AC3 audio), and only once just after changing channels.

To check if its happening in the multidec layer and/or Agarwal's wrapper, it might be worth disabling the multidec support, and trying a free to air unencrypted channel to see if you have the same problem.

[ashwincr]

also what are your diseqc settings?

[sub]

What card are you using? diseqc support is not part of the BDA standard, and only works with a very limited number of devices. If you dont have a diseqc switch, leave it set to none.

[ashwincr]

I have a twinan 102G I do have a Diseqc switch.

[ashwincr]

when I scan, setting DiseqC to none or A, i get a few channels. all come up as unknown. the epg does not get updated, but I can watch these channels in gbpvr, so its a start.

[halcut]

The log looks fine.

To check if its happening in the multidec layer and/or Agarwal's wrapper, it might be worth disabling the multidec support, and trying a free to air unencrypted channel to see if you have the same problem.

Thanks sub will try to do that.

[halcut]

if you decide to scan the dish satellites, do post your results, I am going to try with this new psiparser

Yes I will put my results here as soon as I try dish network. Also my setting is pretty simple right now. no diseqc switch but might add it later on to get dish and bev on same cable.

[ashwincr]

also when I am scanning, my strength and quality always remain at zero!

[halcut]

also when I am scanning, my strength and quality always remain at zero!

thats ok twinhan cards don't give that info.. i tried hauppauge nova s plus and it did give me that info but I got same results. So nothing wrong with twinhan 102g.