Remote Control and wide screen issues

[Zigz14]

Hi, i had a few questions. I have GBPVR 0.99.5 up and running just fine. I currently have 2 TV Tuners, a WinTV PVR 150 MCE and a WinTV PVR 350 using the 45 button Hauppauge remote through the 350 card. Currently the 150 is disabled in deivce manager and i'm using direct access to the remote software and it works fine. Everytime i enable the 150 card, the remote ceases to work. In the config, i have to change the 350 so that it's the second card. Any ideas what would be causing my remote not to work? I'd like to be able to use both cards and the remote if possible. I was forced to give away my MCE remote, or else i would be using that one.

Also, for christmas, i got a new 19" widescreen LCD PC monitor. Everytime i start up Live TV in fullscreen mode, the image is stretched to fit widescreen. I'm currently using Nvidia's PureVideo decoder. Is there any way to set it so that normal TV will displayed in the 4x3 format, but widescreen content like DVDs will still be widescreen?

Lastly, i seem to have an issue with channel changing. After i change the channel about 4 or 5 times in Live TV, the video develops a small pause every 5 seconds. The audio runs smoothly, but the video will freeze up for a moment, then get back in sync with the audio, then freeze up afer about 5 seconds, then get back in sync and repeats. If i exit Live TV and then go back to the same channel, the problem is gone, until i change the channel a few more times. Any ideas? Thanks a bunch yall

[sub]

Hi, i had a few questions. I have GBPVR 0.99.5 up and running just fine. I currently have 2 TV Tuners, a WinTV PVR 150 MCE and a WinTV PVR 350 using the 45 button Hauppauge remote through the 350 card. Currently the 150 is disabled in deivce manager and i'm using direct access to the remote software and it works fine. Everytime i enable the 150 card, the remote ceases to work. In the config, i have to change the 350 so that it's the second card. Any ideas what would be causing my remote not to work? I'd like to be able to use both cards and the remote if possible. I was forced to give away my MCE remote, or else i would be using that one.

From memory, the Hauppauge remote software only works with the last device installed. You can probably correct it by physically removing both cards, then inserting the PVR150 and installing its drivers, then the PVR350.

Also, for christmas, i got a new 19" widescreen LCD PC monitor. Everytime i start up Live TV in fullscreen mode, the image is stretched to fit widescreen. I'm currently using Nvidia's PureVideo decoder. Is there any way to set it so that normal TV will displayed in the 4x3 format, but widescreen content like DVDs will still be widescreen?

Usually it'll do this by default. You may need to go into the nvidia video decoder settings and set the aspect ratio control to 'anamorphic'. Also press F7 a few times in GB-PVR to make sure you're in the 'auto' aspect ratio mode.