Problems Setting up my PVR250 on GBPVR 0.99.5 version

[blkwls]

:confused:
Hi,
Im using a hauppage PVR 250 pci card and getting a feed off my sky box.
Ive just installed GBPVR ver 0.99.5, and ive installed xmltvgui_3.07.00W to get the channels.
Ive set up what i think is correct in the settings, :confused: but i dont seem to be getting a signal when i go to watch a channel, just a screen of what looks like no signal( black and white fuzz)
I use wintv2000 and that is getting a signal and picture, so i can only assume its the settings that are out a bit.
Does anybody have default settings that i can try please or any help at all would be nice
Thanks

[HtV]

did you choose the right source in gbpvr-config-capturesource-direct rec.plugin-source- composite1,2,3/svide01,2 etc.?

[blkwls]

I think ive sorted that now, Thanx.
Only thing is now, the picture is fuzzy and not clear.
Is there any way i can fine tune this:confused:

Thank for the reply

[HtV]

Is the picture ok in wintv2000? If so you might try changing to overlay in gbpvr-config-playback. Wintv2000 uses overlay.

[blkwls]

Yes, the picture is good on wintv2000, I,ll try the overlay setting and get back to you.
Thanx

[blkwls]

Have changed the playback settings to overlay, unfortunately, no difference in the picture quality:confused:
Thanx

[elite]

Which decoder are you using? IIRC I'm using Intervideo and VMR9 with my 350

[blkwls]

At the moment i am using system default-VMR7, but now youve said that i might have a go at the settings again, any suggestions?
I,ll try your settings first.......

[blkwls]

At the moment, i seem to be getting thin vertical lines as interference on the screen. I,m gonna try every different combination........

[K.S.]

give other codecs a chance, you might also try the GPL MPEG2 codec