problem changing channels via MVP

[jackk]

I have had MVP running for about a week. Recently, a problem has developed changing channels. When I attempt to change channels , either by using the channel up/down button, or keying in a number, after a long delay, I get a brief flash of the channel that I am changing to, then the GBPVR menu page comes up. Live TV is highlighted, and after I hit the OK key a few times, the channel that I am changing to appears. This is a new development. It worked OK before.
I have no problem changing channels on my PC, and the delay is definitely shorter. However this difference could be the MVP overhead.

Any suggestions?

Thanks

[sub]

You could try increasing the MVP LiveTV Pre-Play delay setting in the config app. It might be related to this.

[jackk]

In the opening post to this thread, I should have stated that the problem is is changing channels with the remote. No problem changing them on the PC

Sorry

[jackk]

You could try increasing the MVP LiveTV Pre-Play delay setting in the config app. It might be related to this.

I've only been particiapting in this program for a little over a week, and I'm afraid that I haven't had to do this yet. Can you give me some help? Is there a place where I can read about these sort of things, or do you just have to learn by doing?

Thanks

[HtV]

Did you find the wiki yet:
http://gbpvr.com/pmwiki/pmwiki.php/Config/MVP
This is where your issue is explained.

[jackk]

Yes, thank you.

I have been all over it, just knew it by GBPRV-config. I thought it of more of an GBPVR application rather than a MVP. Is app short for something that I should know? Applicaton? Won't forget that one.

Thanks again

[jackk]

I solved my problem by going back and checking the MVP tab configuration. I had a check mark in the "Force ....." even though it was not there in the WIKI. Just sloppiness on my part. So when I detected aproblem with skip, I knew tht I had better check the config first! Solved that one too.