150MCE setup

[nova]

i have a hauppauge 150mce installed in a box that i would like to use as a pvr with gb-pvr

the card seems to be correvtly installed and i can watch a tv stream through it using vlc or
though the simple tv utility that came with the hauppauge drivers shows only a still

however i am unable to get gb-pvr or a simular app called gotallmedia to show live tv or record off the 150


. i was a bit mistified that there was not a section in the setup that selects the capture card, i just 'add' a device in the capture area, which i currenlty have done with 150mce selected and all the i setting i think done.


. other items of note:
i have another tuner card in theis machine, an ati one that i do not want to use for any pvr function
, it seems that the gbpvrrecordingservice will after being on and doing nothing for about 12 hours suddenly start using alot of ram and cpu time.

[nova]

bumb.


any comments at all?
or a better forum to post this?

[sub]

Quote[/b] ]i was a bit mistified that there was not a section in the setup that selects the capture card,

First you need to define a capture source (which defines the relationship between a recording device, an EPG source and a channel changers), then edit the recording source aspect and set the device type to 'PVR150MCE'

Quote[/b] ] it seems that the gbpvrrecordingservice will after being on and doing nothing for about 12 hours suddenly start using alot of ram and cpu time.

Was this at the configured EPG update time?

[black$adder]

Hi,

may be you have the same problem as discussed in Tuning Problems with PVR150?