Error Starting GBPVR on Boot

[firstblackboy]

I have GBPVR set to automatically start on boot, by putting gbpvr.exe in the start up folder. I had it that way before my hard drive crashed and it worked just fine. that was with version 99.5. But when my HDD crashed i rebuilt using 99.12. if i manually start it i can get into it and it runs fine (although the remote doesn't work, but that is a differnt post) but when i shut it down i get an error again. i don't know exactly what error it is, but the error signature says:

EventType : clr20r3 P1 : gbpvr.exe P2 : 1.0.2614.27229 P3 : 5
P4 : system.data.sqlite P5 : 1.0.30.1 P6 : 44a7e70d P7 : 11f
P8 : 2e P9 : system.data.sqlite.sqlite

i get this same error when it auto starts, and thus will not auto start. Any clue. it might be that a rebuild is in order. if so i will as i haven't gotten it to work yet after the rebuild. it wasn't this difficult the first time i installed it, funny i thought i could get this one done in just a couple days.

Any help or suggestions would be appreciated.

Thanks
Erick

[sub]

Sorry, nothing springs to mind. Does it produce any log messages?

[firstblackboy]

not that i noticed. i looked through all the logs, but didn't really see anything that explained anything. i am thinking i may just reload the whole flipping thing. i am having problems with the box itself so i may just reload. dangit it was working perfect til i got a bad HDD error since then nothing but problems. thanks for your help though.

i will look through the logs again to see if i can find anything else. just kind of weird things going on.