Has anybody a girder file for XCard?

[Knaub]

Hi,

I'am just setting up my htpc using XCard for output and PVR350 for cable tv input.
I'd like to use the XCard remote with gb-pvr.
I know there is no support in gb-pvr for XCard remote, a thing I don't really understand
because I think it's much better than the PVR remote.
But the available girder software is able to access gb-pvr.
I downloaded the gbpvr.gml file and opened it in girder, but
I am not that familiar with girder.

So my question is, has anybody set up the gml-file with the
XCard remote, so I don't have to do it again?

Regards, Knaub

[mjp]

you just need to go to each command in turn and tell it too learn the event triggered by pressing a button on the x-card remote.

(Im assuming it activates an event like USB-UIRT does, or that you a girder plugin to allow it too recognise the XCard signals).

Cheers

Mark

[Guest]

Has anyone actually been able to get a girder file working for the x-card remote? If so can you post it? I've been messing with this for a while with no luck at all.