cap source preference

[garymeds]

is this expected :

3 capture sources - 1) bda, 2) cable, 3) bda - in that order.

watch channel available on all chooses source 3 as i would expect, then select a channel only available on source 2, then switch back to initial channel and remains using capture source 2...

attached logs - despite my large number of posts meaning i am senior member, i really signifies i post a lot of questions

many thanks!

ps. channel sequence for logs was 101 (from guide), 110, 101..

[sub]

When you change channels it tries to find the channel on the current capture source first. It'll only change to another capture source if that channel is not available on the current one.

[garymeds]

thanks sub.

i am still getting the weak signal message now and again which i can't remove. if i force standby and wake, it says pvrx2 has stopped responding..

my signal is good as tv's tuner shows ok (via same splitter/amplifier)...

any ideas? this is a nova-t stick and my other bda source is hvr-1300. i'll try changing pref order see if it is the input device.