Problem switching between digital and analog

[sub]

Yes, its still supported in 1.2.9. Reproduce the problem then post the logs and I'll take a look.

[presslab]

Yes, its still supported in 1.2.9. Reproduce the problem then post the logs and I'll take a look.

Thanks for your help!

Attached is my log folder.

[sub]

I cant see any obvious cause in the logs, but have you tried other decoders to see if they behave any differently?

[presslab]

I cant see any obvious cause in the logs, but have you tried other decoders to see if they behave any differently?

Thanks for having a look. I have tried the Cyberlink decoder and it doesn't work either. Switching from digital to analog gives a black screen, although it doesn't freeze up and I can close the program normally. My other installed decoders don't work on my machine.

If I use the Overlay Manager I can get the digital to analog change to work but it gets very dodgy and starts stuttering and eventually the whole program just closes.

[sub]

If you use live preview mode, does it switch correctly?

[presslab]

If you use live preview mode, does it switch correctly?

Yes, live preview mode works fine.

[presslab]

I decided to reinstall my whole computer to start clean with a larger drive, but it didn't fix the channel change issue. I have found that the live preview mode doesn't fully work either; If I change from a digital channel to an analog channel that is already recording it freezes up.

I'm not sure how GBPVR normally handles this as I only have one digital and one analog tuner so I can't test an analog channel change to an analog recording channel.

[sub]

[quote]I have found that the live preview mode doesn't fully work either; If I change from a digital channel to an analog channel that is already recording it freezes up.
[/quiote]I'm not sure if I'll be able to fine anything, but post the logs showing the problem and I'll take another look.