2008-04-25, 06:02 AM
I've got a Hauppauge USB2 TV-Tuner card. I have the grey notched cable plugged into the spot in the front near where it says "Blaster Out". I am skeptical this is where the remote should plug in, but I can't find any other spot and the manual doesn't have pictures. The board doesn't seem to accept remote input. I installed HIP just to see and HIP was not receiving input either from the remote (working batteries; tested on another device) or another remote which is known to work. Am I missing something? Is there a good guide to setting up this remote under GBPVR (I never tried the Hauppauge software, so I don't know if the remote works)?
Thanks!
Thanks!