I've been trying to follow the HIP wiki in GBPVR but have not got any success changing channels. I've decided to start fresh with the HIP config again.
This time, while following the wiki guide, I was only able to follow up till ' Adding GBPVR Commands to HIP'. When I click 'Add Value', a small window does open and asked a key press. When I pressed the 'play' button on my remote, there is no response though. I'm not sure how to proceed from here. Appreciate any help, thanks!
Edit: Managed to get pass the above and the 'play' button has been accepted. However, under 'System Keys/Predefined Keys', there is no 'Play' for me to select. There are the only ones available :
0 1 2 3 4 5 6 7 8 9 Keyboard Emulator, On Screen Display, System Mute, Volume Down, Volume Up.
Under 'Remote I/O-Remote Key Map', I had selected MCE-Remote.hkm.
How are these 'System Keys/Predefined Keys' loaded from?
This time, while following the wiki guide, I was only able to follow up till ' Adding GBPVR Commands to HIP'. When I click 'Add Value', a small window does open and asked a key press. When I pressed the 'play' button on my remote, there is no response though. I'm not sure how to proceed from here. Appreciate any help, thanks!
Edit: Managed to get pass the above and the 'play' button has been accepted. However, under 'System Keys/Predefined Keys', there is no 'Play' for me to select. There are the only ones available :
0 1 2 3 4 5 6 7 8 9 Keyboard Emulator, On Screen Display, System Mute, Volume Down, Volume Up.
Under 'Remote I/O-Remote Key Map', I had selected MCE-Remote.hkm.
How are these 'System Keys/Predefined Keys' loaded from?