2008-04-30, 02:46 PM
When I started Hip for the first time, I had selected MCE as the remote and MCE as the IR Output as well. Is that correct? There is no mention of what to set the IR Output to in the wiki so I assumed it to be MCE as well.
One thing I've always wondered in the back of my mind, I use the hipsend.exe to set #0 to #9 in the Alternate Input section. For the primary command, do I use the MCE remote or my STB remote in the Add/Edit IR Command window?
In any case, once I've used the hipsend.exe to enter #0 to #9 , the Test IR function does not change the channel on my STB though.
I'll fully remove HIP and re-install it again. This time, I'll record my setup step-by-step and post it here for review. Hopefully you guys can help to catch my mistake/s. I can't perform a self-verification anymore.
To zed, yes, I noticed that Hipsend doesn't like it if Hip is not running.
One thing I've always wondered in the back of my mind, I use the hipsend.exe to set #0 to #9 in the Alternate Input section. For the primary command, do I use the MCE remote or my STB remote in the Add/Edit IR Command window?
In any case, once I've used the hipsend.exe to enter #0 to #9 , the Test IR function does not change the channel on my STB though.
I'll fully remove HIP and re-install it again. This time, I'll record my setup step-by-step and post it here for review. Hopefully you guys can help to catch my mistake/s. I can't perform a self-verification anymore.
To zed, yes, I noticed that Hipsend doesn't like it if Hip is not running.