Multi Tuner w/TV-Out remote stops working

[garygamb]

I have a PVR350 and PVR250 on a Pundit (original).  So, I have two PCI slots.  No matter which slot the cards are in, the PVR250 is always recognized as Card #1 by Windows, and thus GB-PVR.  

I'm using the USB-UIRT to control the system, but I'm not using the native USB-UIRT support built into GB-PVR to control the system.  This is due to the USB-UIRT just quiting on me.  I have been able to use Girder to get around this problem.

I have been doing all the testing and initial setup on my computer monitor and now I am ready to use the TV-Out of the PVR350 so I can connect to my TV.  If I change from using the software decoder to using the hardware out of the PVR350, then when I start GB-PVR, I cannot control anything through the remote.  I can control things through the keyboard.  It is as if the USB-UIRT just stops working or is not recognized once I use the TVOut.  

Anyone have any ideas about what could be going on?

[Darx-starz]

Yup seen this. Disable (put a ; in front of) VOLUP and VOLDOWN in the gb-pvr section. Its the bit at the very end of the file. Let us know how you get on.

PS: don't forget to restart IRRemote or reboot.

[garygamb]

Quote[/b] ]Yup seen this. Disable (put a ; in front of) VOLUP and VOLDOWN in the gb-pvr section. Its the bit at the very end of the file. Let us know how you get on.

PS: don't forget to restart IRRemote or reboot.

Tried the above and this had no effect.  I assumed you meant in the irremote.ini?  That is where I put the semicolon in front of the VOLUP and VOLDOWN in the gb-pvr section and then I rebooted.  I'm not running the Hauppauge IR program at all.

I did a little more troubleshooting and if I change from using the girder plugin and go back to the USB-UIRT plugin, then I can control GB-PVR while using the PVR350's tvout functionality.  However, the original problem with USB-UIRT that forced me to go to Girder is still a problem.

see this link for what I'm talking about:
Previous USB-UIRT problem posting

I think the problem lies in how Girder interfaces with GB-PVR, when using the PVR350 TVOut.  Again, it works just fine with not using the TVOut and sending the video to the computer monitor.