Technisat Skystar2

[lrowell]

I just purchased and installed a new Technisat Skystar2 DVB-S PCI card along with the new BDA driver from there web site. The problem is GBPVR detects the card but when I do a scan I get no signal or channels. I have updated the transponder ini files but still nothing. I am located in North America, if anyone could help me out I would be thankful.

[sub]

Do ascan then zip and attach the config.exe.log and config.exe-native.log and I'll take a look.

[lrowell]

thank, but I figured out that would not scan because it does not support a switch.

[kms]

It is the truth that diseqs does not work with SkyStar2? After all in other programs diseqs works and with BDA and WDM drivers.
While I use a sheaf progdvb > dvbsbridge> gbpvr, but it would be desirable that diseqs it was supported without foreign programs.

PS: I Apologize for bad English, I write through the translator

[sub]

True, there is no diseqc support for SkyStar2 devices. Its not covered by the BDA spec so each manufacturer implements it a different way. I have no idea how Technisat implement diseqc support in their BDA drivers. I also dont have any of their devices, so have never tested anything on this type of card.

Other manufacturers (Hauppauge/FireDTV/Twinhan) have supplied sample cards and information to allow me to implement diseqc support. Unfortunately Technisat havnt. Sorry.

[kms]

Let us hope that in the near future, these impact will be solved.
Thank you for the program - GB-PVR, is the best that I tried for Windows.