Technisat skystar 2 usb

[shaigot]

Attached:
1. config log.
2. the screenshot of the scanning ( you can see there high signal and no pic )

In the dvbviewer i picked DiseqC = Pos B/Opt A and work, does this equel to DiseqC B in the gbpvr ( this i picked in the last scanning)?

[sub]

There is no sign of any problems occuring in there.

Maybe double check you've got your LNB settings set correctly.

You could also use some other app to confirm if its receiving channels.

[sub]

In the dvbviewer i picked DiseqC = Pos B/Opt A and work, does this equel to DiseqC B in the gbpvr ( this i picked in the last scanning)?

You added this after I replied.

Diseqc control is not coverted by the BDA spec, so GB-PVR has to implement support for each manufacturer's proprietary scheme that it wants to support. It only implements diseqc control for Hauppauge, Twinhan and FireDTV devices. There is no diseqc control support for Technisat devices.

[shaigot]

So is no solution for my problem ?, for all cards use bda driver ?, why you not supported technisat cards ( is very common ) ?
So what you mean when you select diseq a or b in the configure channel ?

I am using one satellite plate with 2 Diseqc, one for HOTBIRD and the other for AMOS.

[sub]

So is no solution for my problem ?, for all cards use bda driver ?, why you not supported technisat cards ( is very common ) ?

I dont have any technisat cards, or any contacts at technisat, so know very little about them. I do have Twinhan/Hauppauge/FireDTV devices, and these seem much more common here.

So what you mean when you select diseq a or b in the configure channel ?

I am using one satellite plate with 2 Diseqc, one for HOTBIRD and the other for AMOS.

If diseqc worked with your device, you'd setup two capture sources for the one card. One for hotbird with the apprioriate diseqc setting, the other for amos.