my remote (IR) of Hauppauge 1800 not working?

[sz8]

Hi,

I am new to GBPVR. I've installed GBPVR 1.2.13. The basic seems to be
working ok. But I can not make the remote work. Not even in WinTV.
The instruction says plug in the IR device and run ir32.exe, but it seems only
installed the start/stop IR appl. In the device driver list I still see a ? mark
in front of ehome Infrared Transceiver.

For WinTV, if I start IR.exe, it shows up and then disappear in task manager.

When I click on the remote, the LED in the IR does flash. But that is it.

Do anyone know how to make it work? Do I need to install some kind driver
for it?

My system: WINDOW XP PRO SP2, Intel e4500 due core, 4 GB memory, Hauppauge 1800 MCE kit, Nvidia Geforce 7100.

Thanks a lot
SZ

[mmatheny]

Is the IR receiver a USB device? If so, you don't need to install the Hauppauge IR software (would be nice if that was indicated somewhere in the documentation!)
Just pick MCE in the remote type dropdown and you should be good to go.

[sz8]

installed. It works now.

Another question: how do I remove the task bar and the window frame
when showing TV? I want my TV looks like TV instead of a computer
screen .

Thanks again.

SZ

[mmatheny]

ON the first page of the Config, lower right, check box Show in windowed mode. Uncheck it.

[sz8]

Sz