HIP help with MCE remote

[vskatusa]

As per the guide "Adding GBPVR Commands to HIP"

says

select PLAY from "‘system keys / Predefined Keys’" - I do not see the PLAY key in "‘system keys / Predefined Keys’" - Am I missing something here?

[fuzzweed]

I don't think I got any predefined keys when I set up my remote with HIP either. I think you can move on a paragraph and just treat it like the non-predefined buttons.

[vskatusa]

Fuzzweed,

Thanks for your reply. Can you please eloborate on your comments?

I think you can move on a paragraph and just treat it like the non-predefined buttons.

[vskatusa]

I need the GBPVR commands for MCEREMOTE as in the following picture....

Can somebody who have HIP configured with MCEREMOTE v2 please help me!

I need "COMMAND TO BE SENT TO GBPVR" for the following keys:

PLAY
UP
DOWN
OK
CLEAR
ENTER
VOL+
VOL-
CH+
CH-

I followed the wiki and per the wiki the "primary command" can be selected by selecting the appropriate key in the drop down list! I do not see the predefined keys in the drop down list!
Thanks

[vskatusa]

I would really appreciate if somebody can post the HIP file.

I am using GBPVR 1.3.7 with Microsoft MCE Remote 2005 (version 2)

[vskatusa]

The test IR works flawlessly but when I change channels using the GUIDE in GBPVR something interesting happens....

As an example if I press a GUIDE channel 110 the channel changer changes to 11 but drops the 0!

However any two digit channel works flawlessly. As an example if I select channel 24 from the GBPVR GUIDE the channel changer works! Can somebody give me more insights how I can resolve this?

[sub]

Make sure you setup you capture source to use the .exe channel changer and hipsend. You may also need to enable the 'allow service to interact with desktop' setting in the service control panel.

[vskatusa]

You may also need to enable the 'allow service to interact with desktop' setting in the service control panel.

Where is the above settings?

Sub I updated my post! It works but only with 2 digit channel but not 3 digit channels!

[sub]

It works but only with 2 digit channel but not 3 digit channels!

Ah, ok. Its not what I was thinking of then. Sorry. I dont know.