Lockup on Channel change

[brioman]

I have the same issue after getting QAM to work now the analog channels wont display after I change to a digital channel. The analog channels work fine until I change to a QAM channel.
I have tried about three different Codecs. Have you had any luck getting this fixed?

[sub]

I have the same issue after getting QAM to work now the analog channels wont display after I change to a digital channel. The analog channels work fine until I change to a QAM channel.
I have tried about three different Codecs. Have you had any luck getting this fixed?

Did you apply the patches from the survival guide thread? One of them address a problem like this that could occur (when multi-record was enabled).

[brioman]

Thanks for the quick reply!!
I'll find that thread and give it a try

[brioman]

OK, I guess I need a little more guidance, can not find the survival guide thread or the patches. Thanks again for your time, much appreciated.

[brioman]

Oh geez, right after I the last post, I found the survival guide thread, just looking for the patches now.

[brioman]

That did the trick, replaced both of those files and can now see both the Analog and the QAM channels.
Thanks for your help. Now just have to get some sort of EPG figured out and will be good to go.

thanks again!