GBPVR not picking up TVNZ DVB

[stevenb]

I am having problems getting TVNZ channels to show on GBPVR using HVR-4000 and HVR-900 on another computer.


Tried rescanning and they do not show up any one with any ideas.
Two separate computers one with the HVR-900 and one with the HVR-4000.

[sub]

Try running ReRegisterFilters.bat. If you're on Vista or Win7, you'll need to run it from a command prompt started with 'run as administrator'.

If that doesnt help, try rescanning, then zip and attach your config.exe.log and config.exe-native.log, and I'll take a look.

[stevenb]

Thanks Sub
Win XP OS
Tried running reregister filters and no change

Logs are attached

[sub]

I misread your original post, and assumed you were get no NZ channels. I see now you're literally just missing the TVNZ mux channels.

I can see it's actually seeing those TVNZ channels, but there seems to be some garbage in the data, maybe through bad reception, thats stopping the application from being able to parse the channels. Unfortunately I dont really have a lot of suggestions for solving that - I'm not sure why the garbage is there in the first place.

[stevenb]

Thanks Sub

I have attached the Logs this time off the Laptop which is using a different aerial
Are things the same on this as well?

[MCEabused]

Hi sub
I get the same missing TVNZ mux on 538Mhz in 1.4.7 all other muxes are fine on a HVR2200 XPsp3
I just used the scan cache from your previous version, no biggie

TS readerlite and Win7 MCE have no problems with the TVNZ mux on same Hardware

[stevenb]

Hi sub
I get the same missing TVNZ mux on 538Mhz in 1.4.7 all other muxes are fine on a HVR2200 XPsp3
I just used the scan cache from your previous version, no biggie

TS readerlite and Win7 MCE have no problems with the TVNZ mux on same Hardware

Thanks for that
If I go back to 1.3.11 I have no problems

Any ideas Sub?

[sub]

You could try copying your PsiParser.ax file from 1.3.11 over your 1.4.7 install. If you're able to successfully scan in 1.3.11, then there is a good chance it'll get you working on 1.4.7.

[stevenb]

You could try copying your PsiParser.ax file from 1.3.11 over your 1.4.7 install. If you're able to successfully scan in 1.3.11, then there is a good chance it'll get you working on 1.4.7.

Thanks Sub installed 1.3.11 and scanned then installed 1.4.7 over the top and is all working now

[sub]

Ok - great. Good to hear you at least found a work around.