2005-05-01, 04:33 AM
Hello, I installed the GB-PVR software to control my Hauppauge PVR-150. However, as soon as installation was completed it tried to open up the config program. When it did I was given this error.
Application has generated an exception that could not be handled.
Process id=0x22c4 (8900), Thread id=0x2228 (8744).
Click OK to terminate the application.
Click CANCEL to debug the application.
When I click CANCEL to debug:
Registered JIT debugger is not available. An attempt to launch a JIT debugger with the following command resulted in an error code of 0x2 (2). Please check computer settings.
cordbg.exe !a 0x22c4
Does anyone have any idea what my problem is here? I would appreciate any help. Thanks!
Application has generated an exception that could not be handled.
Process id=0x22c4 (8900), Thread id=0x2228 (8744).
Click OK to terminate the application.
Click CANCEL to debug the application.
When I click CANCEL to debug:
Registered JIT debugger is not available. An attempt to launch a JIT debugger with the following command resulted in an error code of 0x2 (2). Please check computer settings.
cordbg.exe !a 0x22c4
Does anyone have any idea what my problem is here? I would appreciate any help. Thanks!
