2010-08-10, 12:02 AM
My PC's motherboard died and I had to reinstall all my applications.
I did a clean install fo PVRX2 version 1.47. I have a Hauppauge 2250 card and two Hauppauge 1600 cards. I've been taking it one step at a time. So far I have only configured one tuner on the 2250 card for Clear QAM and mapped it to the appropriate channels. I was able to successfully watch the channels using WinTV.
From GBPVR's config, I can view and listen to the channel when I map them to the station channels.
I then went into TV Guide and tried to WATCH one of the mapped channels and I get an error saying that "No tuner is available".
I do notice that there are entries in the Task Manager's Processes list that I don't remember seeing before. Are these responsible for me not being able to use the capture card?
I did a clean install fo PVRX2 version 1.47. I have a Hauppauge 2250 card and two Hauppauge 1600 cards. I've been taking it one step at a time. So far I have only configured one tuner on the 2250 card for Clear QAM and mapped it to the appropriate channels. I was able to successfully watch the channels using WinTV.
From GBPVR's config, I can view and listen to the channel when I map them to the station channels.
I then went into TV Guide and tried to WATCH one of the mapped channels and I get an error saying that "No tuner is available".
I do notice that there are entries in the Task Manager's Processes list that I don't remember seeing before. Are these responsible for me not being able to use the capture card?