Wrong channel when recording, but always same wrong channel

[sub]

HaupBlast just asks the Hauppauge software to change to (for example) '102' and the Hauppauge software does the rest. It doesnt send individual numbers or anything like that. All that stuff is hidden from me in the Hauppauge software.

[pBS]

sounds like you should to go into the hauupage blaster software config...there's and 'advanced' setttings button where you can set the timings for individual digits and other things so you may need to play with those settings a bit...
there's delay between individual digits that might solve your problem...
hope that helps..
if not,i was experiencing a system slowdown a while back so i had to start a batch file from gbpvr that would sleep a second then call haupblast.exe with the numbers afterwards, but adfter solving the slowdown i don't need it anymore...
basically you just set cmd.exe as channell changer,then add parameters ' /c batchfilename.cmd' and in the batchfile put a sleep command [e.g. sleep 3] and then 'haupblast.exe %1 %2 %3', effectively adding a pause before sending the channell numbers so the system could calm down after starting the recording..
worked for me at th time..