2005-06-01, 09:16 PM
Hi
Don't know if anybody else has had this problem, but I haven't been able to find it in any other posts.
When I schedule a recording, at the correct time GBPVR switches out of Live Preview Mode and starts to record (I haven't yet trie it with GBPVR not actually running). A couple of seconds later the following message appears.
"Application has generated an exception that could not be handled.
Process id=0x534(1380), thread id=0xd28(3368)"
The program continues to record, and shows as recording on the GBPVR main menu page, however the Recording Service shows as sleeping and stays red.
When the program is scheduled to finish, the next recording shows on the Main Menu page.
If I go into the Recordings menu it is not shown in the Ready section, but still shows as recording in the Pending section even though when played back the actual recording is only 10 or 20 seconds long.
Also, until I either re-start the recording service or sometimes reboot the computer, Live Preview pulls up the
"Error: No connection could be made because the target machine actively refused it" message.
I'm currently using version 0.92.8 with .Net 2.0 Beta 2 capturing from the composite input of a PVR150.
I've tried with .Net 1.1 and I've also tried disabling my sygate personal firewall but I still get the same result.
If I justtry and record a program I'm watching at the time it works fine.
Hope somebody can help.
Cheers,
Nick
Don't know if anybody else has had this problem, but I haven't been able to find it in any other posts.
When I schedule a recording, at the correct time GBPVR switches out of Live Preview Mode and starts to record (I haven't yet trie it with GBPVR not actually running). A couple of seconds later the following message appears.
"Application has generated an exception that could not be handled.
Process id=0x534(1380), thread id=0xd28(3368)"
The program continues to record, and shows as recording on the GBPVR main menu page, however the Recording Service shows as sleeping and stays red.
When the program is scheduled to finish, the next recording shows on the Main Menu page.
If I go into the Recordings menu it is not shown in the Ready section, but still shows as recording in the Pending section even though when played back the actual recording is only 10 or 20 seconds long.
Also, until I either re-start the recording service or sometimes reboot the computer, Live Preview pulls up the
"Error: No connection could be made because the target machine actively refused it" message.
I'm currently using version 0.92.8 with .Net 2.0 Beta 2 capturing from the composite input of a PVR150.
I've tried with .Net 1.1 and I've also tried disabling my sygate personal firewall but I still get the same result.
If I justtry and record a program I'm watching at the time it works fine.
Hope somebody can help.
Cheers,
Nick