HDPVR - Completely Lost

[hdpvr-doug8796]

I sent you a pm, it shows not sent though on my sent messages folder.. Let me know if you got it.

[sub]

Unfortunately it's not letting me collect because the version you're running is out of date.

[hdpvr-doug8796]

Thank you for your patience. I have updated it.

[sub]

Unfortunately bad timing. I've got to head out for 30 minutes. If you're still there when I get back, I'll try again.

[hdpvr-doug8796]

okay

[hdpvr-doug8796]

thanks for looking. it still isnt doing anything. I passed out for a bit.

I did that command and got "m_IRBlasterPort == 0; hcwirblast.dll disabled" when in nextpvr. still black screen?

I had the capture open so you could see the output works, just not nextpvr.

Err it works now! What is the best encoder/decoder?

I will sign up with schedules direct tomorrow. What about getting this setup for mobile devices/android? Is there a good setup place for that?

[sub]

thanks for looking. it still isnt doing anything. I passed out for a bit.

I did that command and got "m_IRBlasterPort == 0; hcwirblast.dll disabled" when in nextpvr. still black screen?

I had the capture open so you could see the output works, just not nextpvr.

I didn't make any changes when I was connected, and it appeared to be blasting fine. I did not see any error message. I could see the set top box was changing to the channel requested. I could see the picture just fine in NextPVR.

[hdpvr-doug8796]

I didn't make any changes when I was connected, and it appeared to be blasting fine. I did not see any error message. I could see the set top box was changing to the channel requested. I could see the picture just fine in NextPVR.

The codec must have done the trick. Is there a script I can run so that the ir continues to fire and not timeout the stb? Also, am I using the best codecs?

[sub]

The codec must have done the trick. Is there a script I can run so that the ir continues to fire and not timeout the stb?

I don't follow what you mean.

Also, am I using the best codecs?

The LAV decoders work well for most people. They should work well for you too.

[hdpvr-doug8796]

I don't follow what you mean.

The LAV decoders work well for most people. They should work well for you too.

My stb has a screensaver after 30min - 1hr of inactivity. Is there a way to pulsate a signal to the box to keep it from doing so? Perhaps setup a bat script to send 0s every so often?