PVR-250 on Windows 2003 Server

[lumstar]

Hi everybody,

I am running Windows 2003 Server, when I install my 250 I get error 10 - Device cannot start. I have enabled directdraw and windows audio service. What other steps are needed to get the PVR-250 working?

The following is my hardware list:
Intel D845EBG2 Motherboard
Pentium 4 2.4 Ghz
512 Mb Ram
Intel Radeon VE (not used for viewing shows, this pc is only a server)
Hauppauge PVR-250
Will add my 350 if i get the 250 working.

I have looked on the Hauppauge forums, but no help there. I noticed quite a few people on here seem to be running a 250 on win2k3 and thought this was the next place to find help.

Any help is greatly appreciated. Thanks in advance!

Lumstar

[sub]

http://www.shspvr.com/smf would be a pretty good place to get an answer to this question.

[Spartan]

FWIW, my 500 went in without a hitch. I did not have to do anything special.

[microkid]

Same here, my PVR150 works without a glitch. Did you use the latest beta drivers?

[lumstar]

I got it working using sub's link. Thank's sub! Basically I needed to enable Windows Audio service and install DirectX 9, then enable Directdraw. After that drivers installed perfectly. Thanks for the help.

Cheers,

Lumstar