USB UIRT setup in V5

[sub]

Well what ever happing to this sub

As mentioned, it was added. ie, when you go to import channels from an HDPVR, you can specify a blaster to run, and arguments to supply.

[shspvr]

Well what ever happing to this sub

As mentioned, it was added. ie, when you go to import channels from an HDPVR, you can specify a blaster to run, and arguments to supply.

That the part you forgot to mention that part where it was at as I thought you going to do a global setting in stead on the import channels any thanks for add it

[jksmurf]

Well what ever happing to this sub

As mentioned, it was added. ie, when you go to import channels from an HDPVR, you can specify a blaster to run, and arguments to supply.

That the part you forgot to mention that part where it was at as I thought you going to do a global setting in stead on the import channels any thanks for add it

sub is the option to specify a blaster and arguments ONLY available when you import channels?

If so would it be possible to add back the batch and arguments screens please? I use these heavily with a cable box.

Thanks

k.

I installed v5 and deleted v4 but I am worried the path is still in the v4 folder and I cannot change (a lot) of them.
   

[sub]

sub is the option to specify a blaster and arguments ONLY available when you import channels?

Yes, at this stage. If you need to change them, you'll likely need to remove your channels and re-add them.

If so would it be possible to add back the batch and arguments screens please? I use these heavily with a cable box.

I'll try to add it in Settings->Devices->HDPVR for the next build.

In the mean time, set your blaster as some batch file, that way you can tweak the commands run (and the parameters) as often as your want (in your batch file).

[mvallevand]

I've got the database in another thread, I will clean it up with sqlite it's pretty straight forward, I will point it to NPVR-data too.

Martin

[jksmurf]

sub is the option to specify a blaster and arguments ONLY available when you import channels?

Yes, at this stage. If you need to change them, you'll likely need to remove your channels and re-add them.

If so would it be possible to add back the batch and arguments screens please? I use these heavily with a cable box.

I'll try to add it in Settings->Devices->HDPVR for the next build.

In the mean time, set your blaster as some batch file, that way you can tweak the commands run (and the parameters) as often as your want (in your batch file).

OK thanks sub, good to see it will be in the next build in case I do need to modify anything. Was hoping to avoid having to do the remove/re-add as there are quite a few channels (probably far fewer than most though), however Martin has very kindly offered to fix my db, for which I am really grateful.  I will try and change all the paths in the scripts as pointed out by Martin.


Thank you both again for helping out, very much appreciated.

k.

[jksmurf]

I've got the database in another thread, I will clean it up with sqlite it's pretty straight forward, I will point it to NPVR-data too.

Martin

Thanks Martin, will try and will reply in the other thread.

k.