Problem with recording out of S3-Standby

[Scorpion]

Hi,

i've installed gbpvr yesterday and generally everything works out fine except a problem with scheduled recording out of the standby-mode.

I scheduled a recording and sent the computer to the standby-mode (S3 Standby). But the scheduled time expires without waking the computer up and start recording. #

Otherwise it is possible to wake the computer up by touching the mouse for example. I installed a tool called "sleeper" (http://www.passmark.com/products/sleeper.htm) and sent the PC into S3-standby-mode for 60 seconds. After those 60 seconds the sleeper-tool woke my pc out of standby-mode. So generally it wake-up out of S3 seems working, but not with gbpvr.

Do you have any tips, what else i could try? I don't want to use the S1 mode.

PS: Please excuse my poor english :mad:

[sub]

It'll be limitation or bug in the drivers for whatever capture device you're using.

[ShiningDragon]

GB-PVR works wonderful from S3 Mode. I tested it with 2 Tuner's at same time by varios channels.

Planned recording, powered down system and let it all be.

All is good and fine. The whole recordings are available.

[Scorpion]

Sorry, that i've forgotten to tell you, that my capture device is a Hauppauge PVR 250.

So do you think a driver update could fix the problem? In the past i downloaded my driver updates from the official german Hauppauge homepage. Are there any other (unofficial) drivers, that could work better?

[Scorpion]

sorry - double post - can be deleted

[ShiningDragon]

Sorry, that i've forgotten to tell you, that my capture device is a Hauppauge PVR 250.

So do you think a driver update could fix the problem? In the past i downloaded my driver updates from the official german Hauppauge homepage. Are there any other (unofficial) drivers, that could work better?

Perhaps one of these?

KLICK

I can't say anyting to this. The last Driver there is dated to December 2004.

And afterward one of this could help:

KLICK