Hauppauge Nova-t PCI install problem.

[Addanc]

I have an early Hauppauge PCI Nova-t installed in my PC box. This runs with the original Hauppauge application and driver S/W.

Downloaded and installed the GBPVR software OK. The GBPVR software cannot detect the Nove-t PCI card :mad:, viz in config utility->Create Capture Source->Recording Source->settings my card is not an option. I noticed on the Home page it mentions support for the Nova-t with BDA drivers. Presumably the original Hauppauge drivers are not BDA compliant (whatever that is). Could this be the source of the problem, and if so can somebody provide a URL when I can obtain suitable drivers.

[sub]

Presumably the original Hauppauge drivers are not BDA compliant (whatever that is). Could this be the source of the problem,

Yes, that is the problem.

and if so can somebody provide a URL when I can obtain suitable drivers.

Sorry, I dont know the URL, but these drivers exist. I'd think they'd be on the Hauppauge UK website, but its possible they're the Technotrend Budget drivers on the http://www.technotrend.de website, since this device was a rebranded one of these.

[Addanc]

There are two chip sets associated with the Nova-t, unfortunately my card has the older chip set which don't appear to work with the techo-trend driver.

[herbs]

Does your one have the grundig or philips tuner? as I beleive the technotrend driver supports both. Well an older BDA driver did, I might still have it. I will check when I get home.

[Bloodnok]

There are two chip sets associated with the Nova-t, unfortunately my card has the older chip set which don't appear to work with the techo-trend driver.

My ancient Nova-T (the original series, referred to as a '909' by GBPVR) installed quite happily with the Technotrend Budget BDA driver - but I had to remove the Hauppauge driver quite thoroughly first. (I haven't been able to make the remote control work afterwards though).