GBPVR Locks Up after pressing skip

[daveo132000]

Im new to GBPVR (I installed it this week into my new PVR system) and am running in to problems. I have installed the .NET 2 runtime, and am running GB-PVR v0.98.13b with no plugins, and the standard blue skin. I have a Hauppauge PVR-500 card, tried the original supplied drivers, and have ubgraded to the 24108 drivers in an attempt to fix this issue.

When I press skip to fast forward a recording, the program locks up solid. I recorded a 10 minute manual recording tonight, with Comskip installed. One press of the skip on a MCE remote locks the application and yields the attached logs.

I tried the same recording with pressing CTRL+ --> to skip and it too locks up.

Can anyone suggest how a newbie like me can figure out what is wrong here?

[HtV]

There are a few things you might try:
- In gbpvr-config-misc select: short skip instead of ff
- Try select another audiodecoder, not stick to default but choose cyberlink audio decoder e.g.
- try vmr 9 instead of vmr 9 custom renderer.
good luck.

[daveo132000]

I experimented for about 2 hours and used different audio settings in the configuration page. I was able to fix the problem. Thanks for the reply.

[#66]

When you say lock up, was it just GPPVR that locked up or did your whole system lock up? I have a similar problem. When I skip with PROCESSED (to xvid) recording I get a total lock up. This behavior is itermittant. Sometime I can skip thru a whole prog. Others lock up after one or two skips.

What were your setting during lock ups and what settings fixed it?

Thanks

[HtV]

Could it be the 150-time-stamp problem?
http://forums.nextpvr.com/showthread.php...+timestamp