pvr150 mono

[Smoker]

Greetings Folks

I've searched but no luck for posts about the pvr-150 only being in mono mode, no stereo. Has anyone run into this ? Resolved it ?

Smoker

[pastro]

How do you know it's the pvr150? Could the audio decoder or the audio renderer be set to mono? Which ones are you using?

[Smoker]

How do you know it's the pvr150? Could the audio decoder or the audio renderer be set to mono? Which ones are you using?

When I go into the parameters for win2000 it shows that the audio is mono.

I've using the system defaults right now. I have not loaded anything beyond the o/s, pvr150 stuff and gbpvr.

[pastro]

When I go into the parameters for win2000 it shows that the audio is mono.

I've using the system defaults right now. I have not loaded anything beyond the o/s, pvr150 stuff and gbpvr.

Ok, make a recording of something that you know is in stereo. (Or at least a part of a recording)
Then look at lastgraph.grf in graphedit. Look at the properties for the Capture filter. You should be able to find an audio ecp tab on that filter. Check if that it is in stereo.
Then look at the encoder filter, check if that is in stereo.
Also look at the tv audio filter, and make sure that is set to stereo.

You can also look using Hauppauge_tweaker.exe. Check out the advanced settings for the 150/500 and look at the capture and encoder settings for each card. There is an audio ecp tab (or something like that) that lets you configure the audio settings. I think there is a link for the tweak tool on the wiki. The TV audio filter will need to be looked at using graphedit though.