Double skip/replay in 1.2.9

[nkh]

I just installed 1.2.9, and it runs almost perfectly, as always I do however have a weird problem..

I'm using an MCE remote (it says "model 1039" on the back), that I've been using with GBpvr for quite some time. The config app is set to use it.

When I hit 'skip' or 'replay' it makes GBpvr jump 120 sec instead of the 60 sec that's set in the config app, and in the Tv guide it skips two days instead of one.

When I use [ctrl] + arrow key, it works like normal.

I have HIP installed (so I can start GBpvr from the remote), but I tried shutting it down, and GBpvr behaves the same way.

[stustunz]

i jsut tried it with HIP disabled and it still jumped 120 sec forward

[stustunz]

tried restarting thinking it might help
it seems like a double button hit
if you halve the time in config it responds so 30 seconds in config jumps 60 seconds
but that doesnt help with jumping 2 days in the guide

[sub]

What do you have remote type set to in the config app? If you have it set to 'MCE Remote', does setting it to 'default' help?

[stustunz]

lol then read your answer
it doesnt respond at all with it se to default (the ok button and arrows do but not the >>| or the |<<)
xp pro on one machine xp media centre 2005 on other
microsoft 2005 remote colours button model

[sub]

Does HIP send something to the application when you press the skip keys? If so, what does it send? My theory for setting it to default is that if HIP is handling the MCE remote buttons and translating them to keys sent to GB-PVR, then GB-PVR doesnt need to also handle those same MCE keys (if they make through to the app). The 'default' setting assumes that any translation to key presses has occurred before it gets to the app, so it'll ignore MCE skip button messages it receives (though it'll still act on keys like Ctrl-Right aka skip).

I have three machines with MCE remotes, and they're all working fine, and are only getting single skips.

[stustunz]

i knew you were going to say that bugger
one machine has hip on it one doesnt and i only use hip to start gbpvr once started i use the mce in config from gbpvr
its does it even if i close hip completely
the keyboard skip works fine

[sub]

Do you get this double skip on the machine that doesnt have HIP?

[stustunz]

yes i do get the double skip on machine with no hip
both were upgrade installs maybe i should try fresh install on the client(laptop)
are there any logs that would tell you whats going on

[sub]

Reproduce the problem on the non-HIP machine, then zip and attach the PVRX2.exe.log and I'll see if I can see anything.