Help Getting the Hauppauge Remote Working

[Anusien]

I've got a Hauppauge USB2 TV-Tuner card. I have the grey notched cable plugged into the spot in the front near where it says "Blaster Out". I am skeptical this is where the remote should plug in, but I can't find any other spot and the manual doesn't have pictures. The board doesn't seem to accept remote input. I installed HIP just to see and HIP was not receiving input either from the remote (working batteries; tested on another device) or another remote which is known to work. Am I missing something? Is there a good guide to setting up this remote under GBPVR (I never tried the Hauppauge software, so I don't know if the remote works)?

Thanks!

[Carlito]

Does that model have a remote plugin? or is the receiver built into the device?
also make sure you are running the ir.exe program to pick up the remote signals.

which version of the usb2 device do you have. There are a few...

[Anusien]

I have ir.exe running. I'm not sure what you mean about the other bit (it has the grey attachment that I think is an IR receiver plug-in).

As far as what version, the label says
24022 LF Rev E1A3 NTSC/NTSC-J
Is that what you mean?

[Carlito]

I think on that model the receiver is located just beside the audio inputs on the front.
The grey attachment i beleive is the ir blaster which you would use to change channels on a set top box.

I don't own a usb2 device so i'm not 100% sure here.

[Anusien]

Yep. Thanks.

Edit: deleted stuff