2013-12-12, 03:09 PM
Migrated from v2.5.9 to 3.1.1 using the general MSI package, and then applied the NPVR 3.1.1 R1 rollup.
Most functions seem to work well, and I find the new OSD TV Guide super useful (thanks!).
However, a couple of basic play functions that I have come to rely on either don't work at all, or are very fragile. I'll focus on skip in particular since I see what appear to be identical errors in the npvr.exe front end.
I can initiate play on normal recordings, but any time I try to mess with skip functions, either short (via >> IR remote key) or long (via ->| IR remote key), NPVR pops up an unhandled exception with a "divide by zero" error. When this happens, the only recovery is to kill the npvr.exe process completely, I've found no other alternative.
This is really bad during chase play, where I simultaneously play a file that is currently recording. Popups are always unhandled exceptions with divide by zero errors.
Last night I captured npvr.exe log data from one such event where I played a normal, completed recording. I then attempted to skip 50 minutes ahead with my usual technique on the IR remote: 5, 0, ->| . This immediately brought forth the unhandled exception/div0 popup. I extracted the corresponding log entries and attached them to this posting.
I'm a little surprised I wasn't able to find similar reports in the forae... hope I'm not out here on my own with this one.
Let me know if I can extract any additional information. Thanks!
Most functions seem to work well, and I find the new OSD TV Guide super useful (thanks!).
However, a couple of basic play functions that I have come to rely on either don't work at all, or are very fragile. I'll focus on skip in particular since I see what appear to be identical errors in the npvr.exe front end.
I can initiate play on normal recordings, but any time I try to mess with skip functions, either short (via >> IR remote key) or long (via ->| IR remote key), NPVR pops up an unhandled exception with a "divide by zero" error. When this happens, the only recovery is to kill the npvr.exe process completely, I've found no other alternative.
This is really bad during chase play, where I simultaneously play a file that is currently recording. Popups are always unhandled exceptions with divide by zero errors.
Last night I captured npvr.exe log data from one such event where I played a normal, completed recording. I then attempted to skip 50 minutes ahead with my usual technique on the IR remote: 5, 0, ->| . This immediately brought forth the unhandled exception/div0 popup. I extracted the corresponding log entries and attached them to this posting.
I'm a little surprised I wasn't able to find similar reports in the forae... hope I'm not out here on my own with this one.
Let me know if I can extract any additional information. Thanks!