S-Video In and remote on PVR-350 not working!

[joshley]

I have a wierd problem:

Firstly I can get GB-PVR to operate fine when using the RF-OUT (NTL STB) to RF-IN (PVR-350), but there is only mono sound because it's RF on 350 (only mono supported). So I now have NTL plugged in via S-Video In on my 350, but whenever I use anything other than the RF option as the source, when I go into LiveTV mode, nothing happens, just blank screen (with the Bleb info on BBC1 at the bottom) and if I click 'Home' on my keyboard, my computer just completely freezes!
Any suggestions? I've tried all other input options, but I just can't seem to get the S-Video In to work at all!
Also, my Hauppauge remote doesn't seem to have any effect on GB-PVR anymore, it used to, but now it doesn't! Batteries are fine and works in WinTV 2000!
Thanks!
josh

[joshley]

Well S-Video wasn't working because my bleedin' cable was directional, which it didn't bleedin' say anywhere! Anyway, still have the remote problem!
josh

[sub]

If you've reinstalled or updated the Hauppauge driver, it would have deleted the GB-PVR entries out of the irremote.ini file.

In the existing [applications] section, you should add:
<table border="0" align="center" width="95%" cellpadding="0" cellspacing="0"><tr><td>Code Sample </td></tr><tr><td id="CODE">GB-PVR=[/QUOTE]

A new section at the end of the file should contain:
<table border="0" align="center" width="95%" cellpadding="0" cellspacing="0"><tr><td>Code Sample </td></tr><tr><td id="CODE">[GB-PVR]
0=0
1=1
2=2
3=3
4=4
5=5
6=6
7=7
8=8
9=9
CHNLUP={UP}
CHNLDOWN={DOWN}
VOLUP={right}
VOLDOWN={left}
OK={enter}
FULLSCREEN={alt}{enter}
BACK={esc}
MENU={home}
STOP={ctrl}S
PAUSE={ctrl}Q
PLAY={ctrl}P
REWIND={ctrl}R
FASTFWD={ctrl}F
SKIPFWD={ctrl}{right}
SKIPREV={ctrl}{left}
RED={ctrl}R
GREEN={ctrl}G
BLUE={ctrl}B
YELLOW={ctrl}Y
;added support to turn of the frontend
GRNPOWER={alt}{F4}[/QUOTE]

[mwtb]

Sorry to resurrect the thread, but can you tell me some more about your setup, joshley?

I have a PVR 250 connected to my NTL Pace box via an S-Video cable from a SCART convertor and I have to run a separate audio cable to get sound (and use composite over the S-Video). Is your setup the same? Just curious, because you make it sound like you only have the S-Video connection.