2006-05-13, 04:47 PM
I have recieved PVR500/radio but was surpriced not to be able to use it on WXP, without 3'part-sw.
I have now installed GB-PVR, which sounds like THE product. However I can't fig out how to get going ;(
The config. contains a lot of abrevations, that tells me nothing, but I setup like following:
Recording device: Name: "TV1" Direct Recording Plugin" -> "hauppauge PVR500" "Denmark" "capture device#1" "internal tuner" "live tv"
EPC source: "none"
"no channel changer requered"
To start I just want to watch TV, on both tuners, and the goon from there.
I have scanned all channels and found ~50 in the channelscanner, but how do I get thos channels into the GBPVR?
I've tried one channel manually which is selectable in TVmode, but this gives very bad and schivering picture.
jm
I have now installed GB-PVR, which sounds like THE product. However I can't fig out how to get going ;(
The config. contains a lot of abrevations, that tells me nothing, but I setup like following:
Recording device: Name: "TV1" Direct Recording Plugin" -> "hauppauge PVR500" "Denmark" "capture device#1" "internal tuner" "live tv"
EPC source: "none"
"no channel changer requered"
To start I just want to watch TV, on both tuners, and the goon from there.
I have scanned all channels and found ~50 in the channelscanner, but how do I get thos channels into the GBPVR?
I've tried one channel manually which is selectable in TVmode, but this gives very bad and schivering picture.
jm