ShowAnalyzer and comclean

[jjaomni]

i have a trial key for ShowAnalyzer and it does every thing it should with producing the right files while it is recording. but i can't seem find where anybody has mentioned what to do with comclean to make it do what it is suppose todo. i read where it said ParallelProcessing.bat was suppose to call it but that just over rides the config.exe settings. right? and the post processing.bat seems to be only for comskip.
i am confused about where to call comclean

[rowle1jt]

In the postprocessing.bat file there is a comclean section near the bottom. You need to remove the "rem" from where the begining of the line where comclean is called.

Here is what to remove highlighted in Bold/Underline:

Rem Once the commercials have been identified you can run comclean to delete the commercials from the recording.
Rem Do this only when you are not using the Skip function in the GBPVR viewer.
Rem To enable comclean remove the word "Rem" from the following line.
rem call comclean %1
:eof

From here on out comclean will read the files produced by comskip and then cut your commericials out for you. This is all I did to mine and it runs GREAT! After I set it up, I scheduled a few random shows to make sure it was all working great, and trust me... after watching a show that has been "cleaned" you will never go back!

Hope that helps for you!

[jjaomni]

how do i turn of the comercail skip in gb-pvr.ece whne i process the file without comercails

[rowle1jt]

There is a checkbox for that in the config.... Its either under "processing" or its on the "Misc." tab.

I'd look and give you a definitive answer.... but VNC isn't wanting to work properly on my machine right now...

[rowle1jt]

Third from the top in the right hand column... its on the "Misc." tab.



This screen shot is from the wiki's "configuration" area. Wiki has a TON of info on it, when I fired up GB-PVR for the first time I spent a couple hours reading through the wiki, and it helped me tremendously.

[pcostanza]

What do I have to have in my Post Processing file if I want SA to automatically start VideoReDo Plus and make a new file? I'm trialing SA as well. Seems to be a nice proggie.

[pcostanza]

What do I have to have in my Post Processing file if I want SA to automatically start VideoReDo Plus and make a new file? I'm trialing SA as well. Seems to be a nice proggie.

I figured out how to tweak this to work with and all seems fine.....I think. More playing needed. I simply took advice from 2 threads and played around until I found what worked best. Didn't mean to be so lazy but for some reason, what I was doing (that seemed right) did not work.