2004-10-19, 07:58 PM
I was getting sick and tired of having to remember to shut down the Hauppauge service prior to starting up GB-PVR, and since I wasn't using it anyway, I just decided to uninstall it.
Since then, I can't get GB-PVR to load into my MVP. It is getting stuck at the "Loading Application" screen. To complicate matters, the MediaMVP is connected wirelessly (via a LinkSys game adapter to a LinkSys router). I have tried just about everything I can think of to get it to work to no avail.
On a whim, I reinstalled the Hauppauge software, and it loads without problem, so I don't think that the wireless connection is the problem. I also disabled the firewall, but that didn't fix anything either.
It appears that after the MVP connects and gets an IP address via DHCP, it starts to transfer data wirelessly, but then stops after a couple seconds and doesn't really get any further than that....
Any ideas why the application would fail to load?
Oyml
UPDATE: After having played around for awhile and reading some of the stuff on this forum, I finally got GB-PVR to load, although in a very round-about way. I had to start the MVP with the Hauppauge software, then start GB-PVR, then shut down the Hauppauge software, causing GB-PVR to show up on the MVP. Kind of a pain, but works just fine.
Since then, I can't get GB-PVR to load into my MVP. It is getting stuck at the "Loading Application" screen. To complicate matters, the MediaMVP is connected wirelessly (via a LinkSys game adapter to a LinkSys router). I have tried just about everything I can think of to get it to work to no avail.
On a whim, I reinstalled the Hauppauge software, and it loads without problem, so I don't think that the wireless connection is the problem. I also disabled the firewall, but that didn't fix anything either.
It appears that after the MVP connects and gets an IP address via DHCP, it starts to transfer data wirelessly, but then stops after a couple seconds and doesn't really get any further than that....
Any ideas why the application would fail to load?
Oyml
UPDATE: After having played around for awhile and reading some of the stuff on this forum, I finally got GB-PVR to load, although in a very round-about way. I had to start the MVP with the Hauppauge software, then start GB-PVR, then shut down the Hauppauge software, causing GB-PVR to show up on the MVP. Kind of a pain, but works just fine.