2006-11-15, 07:35 PM
Today i was impressed with the gbpvr software so much that i went out and got second kworld dvb-100 card as they are on offer here at Maplins and the first one seemed to be working well with gbpvr. anywany, when i had installed the second card,windows installed the drivers i thought all was ok,
so i went into gb pvr setop and installed the second card, but now i find when i tune it, it shows a good signal level and quality, but no channels come up in the listing ?
I also think> im not sure now its been a few hours! that i also tried to retune the first card and go the same results. Since then i have been pulling out cards and reinstalling drivers and testing and searching the net for a solution. Hence , my post!
So if anybody can point be in the right direction ??????????
Regards
Gary
so i went into gb pvr setop and installed the second card, but now i find when i tune it, it shows a good signal level and quality, but no channels come up in the listing ?
I also think> im not sure now its been a few hours! that i also tried to retune the first card and go the same results. Since then i have been pulling out cards and reinstalling drivers and testing and searching the net for a solution. Hence , my post!
So if anybody can point be in the right direction ??????????
Regards
Gary