2007-03-06, 02:43 AM
I'm new to the program, first installed about 3 days ago. I am using a "non-supported" card, a Sony MPEG Realtime Encoder Board in my Sony Vaio RS-430G, but upon my first installation, I added my filters to direct.ini, set everything up in Config, and it worked great. Live TV was working, recording was working, everything was fine. But then after about a couple of days, nothing would work, period. When I try to open Config.exe or GBPVR.exe, either will use about 50% of the processor and will never actually open. GBPVRTray.exe does the same when Windows starts up, until I have to kill the process. The only piece that still seems to run OK is the recording service. I don't receive any errors whatsoever, and attempting to start the application doesn't generate anything in event viewer. I have tried to uninstall, remove all traces of GBPVR from the program folder and the registry, and reinstall, and nothing changed. Unfortunately, I didn't think to keep my logs when removing everything, so the only one that's been created since the reinstall is the one I've attached. Is there some kind of conflict that's likely to cause this problem? I haven't installed or changed anything else since GBPVR was working. I'm completely at a loss. Thanks for any help.